Instructions for self-installation

The MS-Chip units are easy to install within 15 minutes even without special knowledge about the device of the car. All MS-Chip devices come with detailed installation instructions. Also you can use the step-by-step instruction and video materials on our website.

Self-installing MS-Chip and MS-Chip Sport
Self-Installation MS-Chip Speed Boost

Read the step-by-step instructions and install MS-Chip or MS-Chip Sport on your car

1

Step 1

Open the hood and close all doors to the center.

After this, it is necessary to wait 7-10 minutes for the car to turn off the power supply to the sensors.

2

Step 2

Remove the engine top cover, if necessary, before unscrewing the fixing bolts.

3

Step 3

Find the necessary sensors to connect.

4

Step 4

Disconnect the connector from the sensor.

5

Step 5

Connect the cable from the power amplification unit to the sensor and the vehicle's standard connector.

6

Step 6

Connect the MS-Chip to the connector on the cable.

7

Step 7

Open the car and turn on the ignition, on the MS-Chip block the red LED will light, which indicates that the power increase unit is connected correctly.

8

Step 8

Route the cable from the unit to the sensors in such a way that it does not touch the hot parts of the engine.

Video instruction for installing the MS-Chip unit on a BMW X6:

Video instruction for installing the MS Chip Sport unit on a Toyota Land Cruiser 200:

A video instruction for installing the MS Chip Sport unit on Toyota Land Cruiser Prado:

Read the step-by-step instructions and install MS-Chip Speed Boost on your car

1

Step 1

Disconnect the standard connector from the gas pedal. If necessary, unscrew the fixing bolts.

2

Step 2

Connect the connectors from the Speed ​​Boost to the gas pedal and the ground connector, previously disconnected from the gas drop.

3

Step 3

Turn the ignition on. The orange indicator on the remote control will light, indicating correct installation.

4

Step 4

Place the control panel in any convenient place, fixing it with sticky stickers.

A video instruction for installing the MS-Chip Speed ​​Boost unit on a Land Rover Vogue car:

Installation MS-Chip

3 years warranty on installation

Experts know all the subtleties of different brands of cars

Support at all stages of installation

You can pass a test drive with the wizard immediately after installing the unit

order installation