Step 1

Open the hood and close all doors to the center.

After this, it is necessary to wait 7-10 minutes for the car to turn off the power supply to the sensors.

Step 2

Remove the engine top cover, if necessary, before unscrewing the fixing bolts.

Step 3

Find the necessary sensors to connect.

Step 4

Disconnect the connector from the sensor.

Step 5

Connect the cable from the power amplification unit to the sensor and the vehicle's standard connector.

Step 6

Connect the MS-Chip to the connector on the cable.

Step 7

Open the car and turn on the ignition, on the MS-Chip block the red LED will light, which indicates that the power increase unit is connected correctly.

Step 8

Route the cable from the unit to the sensors in such a way that it does not touch the hot parts of the engine.

Step 1

Disconnect the standard connector from the gas pedal. If necessary, unscrew the fixing bolts.

Step 2

Connect the connectors from the Speed ​​Boost to the gas pedal and the ground connector, previously disconnected from the gas drop.

Step 3

Turn the ignition on. The orange indicator on the remote control will light, indicating correct installation.

Step 4

Place the control panel in any convenient place, fixing it with sticky stickers.